Atomstack A5 Pro — Anodized Aluminum

What speed should I use to engrave Anodized Aluminum on the Atomstack A5 Pro?

The top-rated community setting uses 1500 mm/min at 80% power. Removes anodising cleanly to reveal bright aluminium underneath. Even 5W is sufficient for anodised aluminium — the anodised layer is very thin and absorbs the diode wavelength well. Excellent for dog tags, tumblers, and phone cases. No coating needed.

Can the Atomstack A5 Pro cut Anodized Aluminum?

A 10W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Atomstack A5 Pro need to engrave Anodized Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Anodized Aluminum on the Atomstack A5 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Anodized Aluminum on the Atomstack A5 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.