Bambu Lab Laser Module 40W: Slate

What speed should I use to engrave Slate on the Bambu Lab Laser Module 40W?

The top-rated community setting uses 2500 mm/min at 65% power. Conservative starting point derived from the 20W-class diode baseline.

Can the Bambu Lab Laser Module 40W cut Slate?

Cutting Slate on the Bambu Lab Laser Module 40W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Bambu Lab Laser Module 40W need to engrave Slate?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Slate on the Bambu Lab Laser Module 40W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the Bambu Lab Laser Module 40W for Slate?

The Bambu Lab Laser Module 40W works with Bambu Studio. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.