Boss LS-1420: Rowmark Engraving Plastic

What speed should I use to score Rowmark Engraving Plastic on the Boss LS-1420?

The top-rated community setting uses 250 mm/s at 8% power. Vector score to remove the top color layer only -- do not cut through. Remove masking film first.

How many passes does the Boss LS-1420 need to engrave Rowmark Engraving Plastic?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Rowmark Engraving Plastic on the Boss LS-1420?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the Boss LS-1420 for Rowmark Engraving Plastic?

The Boss LS-1420 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.