Boss LS-1630 — Cork 3mm
1 community-tested setting for cut Cork 3mm on the Boss LS-1630. Always run a test on scrap material first.
These 1 setting cover cut Cork 3mm on the Boss LS-1630 (100W CO₂ laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition.
1 setting
Frequently asked questions
What speed should I use to cut Cork 3mm on the Boss LS-1630?
The top-rated community setting uses 45 mm/s at 30% power. 100W CO2 cuts cork at very low power — keep speed high to avoid over-burning.
How many passes does the Boss LS-1630 need to cut Cork 3mm?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Cork 3mm on the Boss LS-1630?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
Now make something with Cork 3mm
Templates ready to cut on your Boss LS-1630 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris