Boss LS-1630 — Rubber Stamp Material
2 community-tested settings for cut, engrave Rubber Stamp Material on the Boss LS-1630. Always run a test on scrap material first.
These 2 settings cover cut and engrave Rubber Stamp Material on the Boss LS-1630 (100W CO₂ laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition.
2 settings
Frequently asked questions
What speed should I use to cut Rubber Stamp Material on the Boss LS-1630?
The top-rated community setting uses 17 mm/s at 85% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the Boss LS-1630 need to cut Rubber Stamp Material?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Rubber Stamp Material on the Boss LS-1630?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What DPI should I use to engrave Rubber Stamp Material on the Boss LS-1630?
Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.
Now make something with Rubber Stamp Material
Templates ready to cut on your Boss LS-1630 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris