Creality Falcon2 — Anodized Aluminum

What speed should I use to engrave Anodized Aluminum on the Creality Falcon2?

The top-rated community setting uses 1500 mm/min at 80% power. Higher DPI for fine text and logos on anodized aluminum. Slower speed with lower power gives crisper edges.

Can the Creality Falcon2 cut Anodized Aluminum?

A 22W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Creality Falcon2 need to engrave Anodized Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Anodized Aluminum on the Creality Falcon2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Anodized Aluminum on the Creality Falcon2?

Settings here use 254–400 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Creality Falcon2 for Anodized Aluminum?

The Creality Falcon2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.