Creality Falcon2 — Cardstock
2 community-tested settings for engrave, cut Cardstock on the Creality Falcon2. Always run a test on scrap material first.
Where to buy
Buy the Creality Falcon2 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut Cardstock on the Creality Falcon2 (22W diode laser). Keep speeds high and power low to avoid burning through; masking tape on the surface reduces scorching around cut edges.
2 settings
Frequently asked questions
What speed should I use to engrave Cardstock on the Creality Falcon2?
The top-rated community setting uses 6000 mm/min at 15% power. Creality Falcon2 22W official wiki and Scribd 661034488: 15% power, 6000 mm/min, 1 pass for 0.2mm red card paper engrave. store.creality.com parameter guide confirms this entry. Recommended to test darker card colors at slightly lower power as dark pigment absorbs more energy.
How many passes does the Creality Falcon2 need to cut Cardstock?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Cardstock on the Creality Falcon2?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What software do I use with the Creality Falcon2 for Cardstock?
The Creality Falcon2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Cardstock
Templates ready to cut on your Creality Falcon2 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris