Creality Falcon2 — Foam Board 5mm
2 community-tested settings for engrave, cut Foam Board 5mm on the Creality Falcon2. Always run a test on scrap material first.
Where to buy
Buy the Creality Falcon2 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut Foam Board 5mm on the Creality Falcon2 (22W diode laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition. Some settings use multiple passes for a cleaner cut — pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to engrave Foam Board 5mm on the Creality Falcon2?
The top-rated community setting uses 8000 mm/min at 15% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the Creality Falcon2 need to cut Foam Board 5mm?
Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.
Do I need air assist for Foam Board 5mm on the Creality Falcon2?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Foam Board 5mm on the Creality Falcon2?
Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
What software do I use with the Creality Falcon2 for Foam Board 5mm?
The Creality Falcon2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Foam Board 5mm
Templates ready to cut on your Creality Falcon2 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris