Glowforge Basic — Basswood

What speed should I use to cut Basswood on the Glowforge Basic?

The top-rated community setting uses 25 mm/s at 70% power. Basswood CO2 cut — single pass on thin sheet (3mm). Increase to 2 passes for denser hardwood batches.

How many passes does the Glowforge Basic need to cut Basswood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Basswood on the Glowforge Basic?

Yes — 2 of the 3 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Basswood on the Glowforge Basic?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Glowforge Basic for Basswood?

The Glowforge Basic works with Glowforge App. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.