Longer Ray5 — 3mm Clear Acrylic (Cast)

What speed should I use to engrave 3mm Clear Acrylic (Cast) on the Longer Ray5?

The top-rated community setting uses 1500 mm/min at null% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the Longer Ray5 need to engrave 3mm Clear Acrylic (Cast)?

Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.

Do I need air assist for 3mm Clear Acrylic (Cast) on the Longer Ray5?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave 3mm Clear Acrylic (Cast) on the Longer Ray5?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Longer Ray5 for 3mm Clear Acrylic (Cast)?

The Longer Ray5 works with LightBurn,LaserGRBL. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.