Monport GP 40W CO2 — Copy Paper 80gsm

What speed should I use to engrave Copy Paper 80gsm on the Monport GP 40W CO2?

The top-rated community setting uses 500 mm/s at 8% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the Monport GP 40W CO2 need to cut Copy Paper 80gsm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Copy Paper 80gsm on the Monport GP 40W CO2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Copy Paper 80gsm on the Monport GP 40W CO2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Monport GP 40W CO2 for Copy Paper 80gsm?

The Monport GP 40W CO2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.