OMTech Polar — Rubber Stamp Material
2 community-tested settings for engrave, cut Rubber Stamp Material on the OMTech Polar. Always run a test on scrap material first.
These 2 settings cover engrave and cut Rubber Stamp Material on the OMTech Polar (30W CO₂ laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition.
2 settings
Frequently asked questions
What speed should I use to engrave Rubber Stamp Material on the OMTech Polar?
The top-rated community setting uses 150 mm/s at 28% power. Invert design for good stamp relief.
How many passes does the OMTech Polar need to cut Rubber Stamp Material?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Rubber Stamp Material on the OMTech Polar?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Rubber Stamp Material on the OMTech Polar?
Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.
Now make something with Rubber Stamp Material
Templates ready to cut on your OMTech Polar once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris