Ortur Laser Master 3: HDPE (Cutting Board)

What speed should I use to engrave HDPE (Cutting Board) on the Ortur Laser Master 3?

The top-rated community setting uses 2000 mm/min at 56% power. Engrave only -- HDPE melts and gums up rather than cutting cleanly, leaving a rough, melted kerf. Not toxic, just a poor cut; use a router/CNC if you need it cut.

Can the Ortur Laser Master 3 cut HDPE (Cutting Board)?

Cutting HDPE (Cutting Board) on the Ortur Laser Master 3 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Ortur Laser Master 3 need to engrave HDPE (Cutting Board)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for HDPE (Cutting Board) on the Ortur Laser Master 3?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the Ortur Laser Master 3 for HDPE (Cutting Board)?

The Ortur Laser Master 3 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.