Ortur Laser Master 3 — Powder Coated Steel

What speed should I use to engrave Powder Coated Steel on the Ortur Laser Master 3?

The top-rated community setting uses 2000 mm/min at 90% power. Ablates powder coat to expose bare metal. Clean with IPA first. Black powder coat gives highest contrast. No Cermark needed.

Can the Ortur Laser Master 3 cut Powder Coated Steel?

A 10W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Ortur Laser Master 3 need to engrave Powder Coated Steel?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Powder Coated Steel on the Ortur Laser Master 3?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Powder Coated Steel on the Ortur Laser Master 3?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Ortur Laser Master 3 for Powder Coated Steel?

The Ortur Laser Master 3 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.