Sculpfun S9 — Rubber Stamp Blank
2 community-tested settings for cut, engrave Rubber Stamp Blank on the Sculpfun S9. Always run a test on scrap material first.
Where to buy
Buy the Sculpfun S9 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover cut and engrave Rubber Stamp Blank on the Sculpfun S9 (10W diode laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition. Some settings use multiple passes for a cleaner cut — pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to cut Rubber Stamp Blank on the Sculpfun S9?
The top-rated community setting uses 600 mm/min at 100% power, 2 passes. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the Sculpfun S9 need to cut Rubber Stamp Blank?
Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.
Do I need air assist for Rubber Stamp Blank on the Sculpfun S9?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What DPI should I use to engrave Rubber Stamp Blank on the Sculpfun S9?
Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
What software do I use with the Sculpfun S9 for Rubber Stamp Blank?
The Sculpfun S9 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Rubber Stamp Blank
Templates ready to cut on your Sculpfun S9 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris