Trotec Speedy 100: Slate

What speed should I use to engrave Slate on the Trotec Speedy 100?

The top-rated community setting uses 300 mm/s at 60% power. Consistent with the 55-60W CO2 baseline used across the settings database.

Can the Trotec Speedy 100 cut Slate?

Cutting Slate on the Trotec Speedy 100 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Trotec Speedy 100 need to engrave Slate?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Slate on the Trotec Speedy 100?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the Trotec Speedy 100 for Slate?

The Trotec Speedy 100 works with Trotec Ruby. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.