Two Trees TS2 — Anodized Aluminum

What speed should I use to engrave Anodized Aluminum on the Two Trees TS2?

The top-rated community setting uses 2000 mm/min at 75% power. Removes the anodised layer to reveal bright aluminium. No coating needed — diode lasers remove anodising cleanly. Great for dog tags, tumblers, and branded accessories. Use a rotary attachment for cylindrical items like tumblers.

Can the Two Trees TS2 cut Anodized Aluminum?

A 10W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Two Trees TS2 need to engrave Anodized Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Anodized Aluminum on the Two Trees TS2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Anodized Aluminum on the Two Trees TS2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.