Two Trees TS3: 3mm Clear Acrylic
2 community-tested settings for engrave, cut 3mm Clear Acrylic on the Two Trees TS3. Always run a test on scrap material first.
Where to buy
Two Trees TS3: check current price & availability
Affiliate link: we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut 3mm Clear Acrylic on the Two Trees TS3 (10W diode laser). Cast acrylic engraves more cleanly than extruded; for cutting, a single clean pass at the right speed usually beats multiple passes. Some settings use multiple passes for a cleaner cut: pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to engrave 3mm Clear Acrylic on the Two Trees TS3?
The top-rated community setting uses 2500 mm/min at 45% power. Same 10W-class engrave baseline used for the TS2.
How many passes does the Two Trees TS3 need to cut 3mm Clear Acrylic?
Settings here range from 1 to 3 passes. Multiple passes give a cleaner edge but increase the risk of material shift: always pin or tape your material flat before running.
Do I need air assist for 3mm Clear Acrylic on the Two Trees TS3?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
Now make something with 3mm Clear Acrylic
Templates ready to cut on your Two Trees TS3 once you've dialed in the settings.
"Used it with a Glowforge: engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
: Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once: making that job so much easier."
: Camp
"Excellent quality and design. Cut clean and neat!"
: LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
: Bruce
"Excellent quality. Item as described. Expectations exceeded."
: Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
: chris