WeCreat Vision: Anodized Aluminum

What speed should I use to engrave Anodized Aluminum on the WeCreat Vision?

The top-rated community setting uses 4000 mm/min at 55% power. Estimated: copied from a different brand's real settings at the same power/laser-type class -- no same-brand data exists yet for this machine. Unverified, more speculative than same-brand estimates -- treat as a rough starting point only.

Can the WeCreat Vision cut Anodized Aluminum?

A 20W diode laser can mark or engrave metal surfaces but cannot cut through them: metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the WeCreat Vision need to engrave Anodized Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Anodized Aluminum on the WeCreat Vision?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.