xTool D1 Pro — 2mm Basswood Plywood

What speed should I use to engrave 2mm Basswood Plywood on the xTool D1 Pro?

The top-rated community setting uses 6000 mm/min at 50% power. 2mm basswood engraves with deep contrast. 300 DPI is the sweet spot — higher increases burn time significantly.

How many passes does the xTool D1 Pro need to cut 2mm Basswood Plywood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for 2mm Basswood Plywood on the xTool D1 Pro?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave 2mm Basswood Plywood on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for 2mm Basswood Plywood?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.