xTool D1 Pro — 9mm Birch Plywood

What speed should I use to engrave 9mm Birch Plywood on the xTool D1 Pro?

The top-rated community setting uses 3500 mm/min at 70% power. 9mm birch engraves cleanly. For deeper relief reduce speed or raise power.

Can the xTool D1 Pro cut 9mm Birch Plywood?

Cutting 9mm Birch Plywood on the xTool D1 Pro may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool D1 Pro need to engrave 9mm Birch Plywood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for 9mm Birch Plywood on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave 9mm Birch Plywood on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for 9mm Birch Plywood?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.