xTool D1 Pro — Bamboo 3mm

What speed should I use to engrave Bamboo 3mm on the xTool D1 Pro?

The top-rated community setting uses 6000 mm/min at 55% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the xTool D1 Pro need to cut Bamboo 3mm?

Settings here range from 1 to 3 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.

Do I need air assist for Bamboo 3mm on the xTool D1 Pro?

Yes — 3 of the 4 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Bamboo 3mm on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for Bamboo 3mm?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.