xTool D1 Pro — Basswood
2 community-tested settings for engrave, cut Basswood on the xTool D1 Pro. Always run a test on scrap material first.
Where to buy
Buy the xTool D1 Pro — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut Basswood on the xTool D1 Pro (20W diode laser). Wood results vary by grain direction and moisture content — always run a quick test on scrap before cutting your final piece. Some settings use multiple passes for a cleaner cut — pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to engrave Basswood on the xTool D1 Pro?
The top-rated community setting uses 4000 mm/min at 70% power. Higher speed with more power for faster production runs. Slightly lighter result than s001 but much faster cycle time. Good for batch production.
How many passes does the xTool D1 Pro need to cut Basswood?
Settings here range from 1 to 4 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.
Do I need air assist for Basswood on the xTool D1 Pro?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What DPI should I use to engrave Basswood on the xTool D1 Pro?
Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
What software do I use with the xTool D1 Pro for Basswood?
The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Basswood
Templates ready to cut on your xTool D1 Pro once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris