xTool D1 Pro — Cardboard (corrugated, ~3–4mm)

What speed should I use to engrave Cardboard (corrugated, ~3–4mm) on the xTool D1 Pro?

The top-rated community setting uses 400 mm/s at 30% power. Light surface engrave without cutting through. Keep power low.

How many passes does the xTool D1 Pro need to cut Cardboard (corrugated, ~3–4mm)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cardboard (corrugated, ~3–4mm) on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Cardboard (corrugated, ~3–4mm) on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for Cardboard (corrugated, ~3–4mm)?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.