xTool D1 Pro — Cork

What speed should I use to cut Cork on the xTool D1 Pro?

The top-rated community setting uses 800 mm/min at 85% power, 2 passes. Cork cut — 2 passes at moderate speed. Pin or tape edges as cork is springy and can shift.

How many passes does the xTool D1 Pro need to cut Cork?

Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.

Do I need air assist for Cork on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Cork on the xTool D1 Pro?

Settings here use 169–300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for Cork?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.