xTool D1 Pro — Paper

What speed should I use to engrave Paper on the xTool D1 Pro?

The top-rated community setting uses 5000 mm/min at 15% power. Very low power for surface marking without cutting through. Good for personalising notebooks and journals.

How many passes does the xTool D1 Pro need to cut Paper?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Paper on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Paper on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for Paper?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.