xTool D1 Pro: Polycarbonate (Lexan)

What speed should I use to engrave Polycarbonate (Lexan) on the xTool D1 Pro?

The top-rated community setting uses 3450 mm/min at 53% power. Engrave only -- polycarbonate scorches, yellows, and can craze/crack if you try to cut it with a CO2 or diode laser. Low power, high speed, single pass.

Can the xTool D1 Pro cut Polycarbonate (Lexan)?

Cutting Polycarbonate (Lexan) on the xTool D1 Pro may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool D1 Pro need to engrave Polycarbonate (Lexan)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Polycarbonate (Lexan) on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the xTool D1 Pro for Polycarbonate (Lexan)?

The xTool D1 Pro works with xTool Studio and xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.