xTool D1 Pro — Washi Tape

What speed should I use to cut Washi Tape on the xTool D1 Pro?

The top-rated community setting uses 800 mm/min at 20% power. Very low power for clean tape cutting. Great for custom tape shapes and stickers. Leave tape on its backing — cut through tape only, not backing.

How many passes does the xTool D1 Pro need to cut Washi Tape?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Washi Tape on the xTool D1 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Washi Tape on the xTool D1 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool D1 Pro for Washi Tape?

The xTool D1 Pro works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.