xTool F1 Ultra (UV) — Bamboo 3mm

What speed should I use to engrave Bamboo 3mm on the xTool F1 Ultra (UV)?

The top-rated community setting uses 300 mm/s at 80% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

Can the xTool F1 Ultra (UV) cut Bamboo 3mm?

Cutting Bamboo 3mm on the xTool F1 Ultra (UV) may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool F1 Ultra (UV) need to engrave Bamboo 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Bamboo 3mm on the xTool F1 Ultra (UV)?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the xTool F1 Ultra (UV) for Bamboo 3mm?

The xTool F1 Ultra (UV) works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.