xTool F1 Ultra (UV) — Basswood

What speed should I use to engrave Basswood on the xTool F1 Ultra (UV)?

The top-rated community setting uses 600 mm/s at 45% power. UV engraves basswood with sharp detail. Less char than IR diode.

Can the xTool F1 Ultra (UV) cut Basswood?

Cutting Basswood on the xTool F1 Ultra (UV) may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool F1 Ultra (UV) need to engrave Basswood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Basswood on the xTool F1 Ultra (UV)?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Basswood on the xTool F1 Ultra (UV)?

Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.

What software do I use with the xTool F1 Ultra (UV) for Basswood?

The xTool F1 Ultra (UV) works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.