xTool F1 Ultra (UV) — Cork

What speed should I use to engrave Cork on the xTool F1 Ultra (UV)?

The top-rated community setting uses 500 mm/s at 35% power. Clean UV engrave on cork coasters.

Can the xTool F1 Ultra (UV) cut Cork?

Cutting Cork on the xTool F1 Ultra (UV) may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool F1 Ultra (UV) need to engrave Cork?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cork on the xTool F1 Ultra (UV)?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the xTool F1 Ultra (UV) for Cork?

The xTool F1 Ultra (UV) works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.