xTool F1 Ultra (UV) — Glass

What speed should I use to engrave Glass on the xTool F1 Ultra (UV)?

The top-rated community setting uses 300 mm/s at 35% power. Frost effect on clear glass. UV doesn't crack glass like IR.

How many passes does the xTool F1 Ultra (UV) need to engrave Glass?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Glass on the xTool F1 Ultra (UV)?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Glass on the xTool F1 Ultra (UV)?

Settings here use 600 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.

What software do I use with the xTool F1 Ultra (UV) for Glass?

The xTool F1 Ultra (UV) works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.