xTool F1 — Bare Aluminum

What speed should I use to engrave Bare Aluminum on the xTool F1?

The top-rated community setting uses 800 mm/min at 95% power, 2 passes. Deep ablative engrave into raw aluminum. 2 passes at near max power for a visible groove. Good for nameplates and signage where a tactile mark is needed. Expect some burr on edges — clean with a fine file or brass brush.

How many passes does the xTool F1 need to engrave Bare Aluminum?

Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.

Do I need air assist for Bare Aluminum on the xTool F1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Bare Aluminum on the xTool F1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.