xTool F1 — Brass
2 community-tested settings for mark, engrave Brass on the xTool F1. Always run a test on scrap material first.
Where to buy
Buy the xTool F1 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover mark and engrave Brass on the xTool F1 (2W fiber laser). Metal marking typically requires Cermark spray or an anodized coating — bare metal cutting needs a much higher-powered machine.
2 settings
Frequently asked questions
What speed should I use to mark Brass on the xTool F1?
The top-rated community setting uses 200 mm/s at 100% power, 3 passes. 2W fiber can produce a light surface mark on brass. Deep engraving is not realistic at 2W. Multiple passes required. The F1 Ultra (20W) is recommended for brass. Use as a marking/ID tool only. xTool material guide confirms brass compatibility with IR module. | Freq: 40kHz, line interval: 0.04mm
How many passes does the xTool F1 need to engrave Brass?
Settings here range from 1 to 3 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.
Do I need air assist for Brass on the xTool F1?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Brass on the xTool F1?
Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
Now make something with Brass
Templates ready to cut on your xTool F1 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris