xTool F1 — Powder Coated Aluminum

What speed should I use to mark Powder Coated Aluminum on the xTool F1?

The top-rated community setting uses 3000 mm/min at 62% power. Removes powder coat to expose bare aluminum beneath — high contrast matte-to-metal look. Works on any powder coat colour. Commonly used for tumblers, keychains, water bottles, and signage panels. No need to remove paint first.

How many passes does the xTool F1 need to engrave Powder Coated Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Powder Coated Aluminum on the xTool F1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Powder Coated Aluminum on the xTool F1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.