xTool S1 — 3mm Baltic Birch Plywood

What speed should I use to cut 3mm Baltic Birch Plywood on the xTool S1?

The top-rated community setting uses 550 mm/min at 100% power. Single pass at full power. Consistent results across whole sheet.

How many passes does the xTool S1 need to cut 3mm Baltic Birch Plywood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for 3mm Baltic Birch Plywood on the xTool S1?

Yes — 2 of the 3 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave 3mm Baltic Birch Plywood on the xTool S1?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for 3mm Baltic Birch Plywood?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.