xTool S1: 3mm Clear Acrylic
2 community-tested settings for cut 3mm Clear Acrylic on the xTool S1. Always run a test on scrap material first.
Where to buy
xTool S1: check current price & availability
Affiliate link: we may earn a small commission at no extra cost to you.
These 2 settings cover cut 3mm Clear Acrylic on the xTool S1 (40W diode laser). Cast acrylic engraves more cleanly than extruded; for cutting, a single clean pass at the right speed usually beats multiple passes. Some settings use multiple passes for a cleaner cut: pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to cut 3mm Clear Acrylic on the xTool S1?
The top-rated community setting uses 500 mm/min at 100% power. Clean flame-polished edge on clear acrylic. Remove film before cutting.
How many passes does the xTool S1 need to cut 3mm Clear Acrylic?
Settings here range from 1 to 4 passes. Multiple passes give a cleaner edge but increase the risk of material shift: always pin or tape your material flat before running.
Do I need air assist for 3mm Clear Acrylic on the xTool S1?
Yes: 2 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What software do I use with the xTool S1 for 3mm Clear Acrylic?
The xTool S1 works with xTool Studio and xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.
Now make something with 3mm Clear Acrylic
Templates ready to cut on your xTool S1 once you've dialed in the settings.
"Used it with a Glowforge: engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
: Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once: making that job so much easier."
: Camp
"Excellent quality and design. Cut clean and neat!"
: LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
: Bruce
"Excellent quality. Item as described. Expectations exceeded."
: Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
: chris