xTool S1 — 9mm Birch Plywood

What speed should I use to engrave 9mm Birch Plywood on the xTool S1?

The top-rated community setting uses 4000 mm/min at 60% power. 9mm birch engraves cleanly. For deeper relief reduce speed or raise power.

How many passes does the xTool S1 need to cut 9mm Birch Plywood?

Settings here range from 1 to 6 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.

Do I need air assist for 9mm Birch Plywood on the xTool S1?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave 9mm Birch Plywood on the xTool S1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for 9mm Birch Plywood?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.