xTool S1 — Cardboard (corrugated, ~3–4mm)

What speed should I use to engrave Cardboard (corrugated, ~3–4mm) on the xTool S1?

The top-rated community setting uses 500 mm/s at 25% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the xTool S1 need to cut Cardboard (corrugated, ~3–4mm)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cardboard (corrugated, ~3–4mm) on the xTool S1?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Cardboard (corrugated, ~3–4mm) on the xTool S1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for Cardboard (corrugated, ~3–4mm)?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.