xTool S1 — Cardstock (80–110 lb / ~220–300 gsm)

What speed should I use to engrave Cardstock (80–110 lb / ~220–300 gsm) on the xTool S1?

The top-rated community setting uses 500 mm/s at 12% power. Heavy cardstock — go fast and light to avoid charring. No air assist to prevent sheet lifting.

How many passes does the xTool S1 need to cut Cardstock (80–110 lb / ~220–300 gsm)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cardstock (80–110 lb / ~220–300 gsm) on the xTool S1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Cardstock (80–110 lb / ~220–300 gsm) on the xTool S1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for Cardstock (80–110 lb / ~220–300 gsm)?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.