xTool S1 — Coated / Powder Coated Steel

What speed should I use to engrave Coated / Powder Coated Steel on the xTool S1?

The top-rated community setting uses 3000 mm/min at 70% power. Ablates powder coat to reveal bare metal beneath. Works on powder coated panels, signs, and flat stock. Clean with IPA first. Black powder coat gives highest contrast. No Cermark needed — laser burns off the coating directly.

Can the xTool S1 cut Coated / Powder Coated Steel?

A 40W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the xTool S1 need to engrave Coated / Powder Coated Steel?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Coated / Powder Coated Steel on the xTool S1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Coated / Powder Coated Steel on the xTool S1?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for Coated / Powder Coated Steel?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.