xTool S1 — Paper
2 community-tested settings for engrave, cut Paper on the xTool S1. Always run a test on scrap material first.
Where to buy
Buy the xTool S1 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut Paper on the xTool S1 (40W diode laser). Keep speeds high and power low to avoid burning through; masking tape on the surface reduces scorching around cut edges.
2 settings
Frequently asked questions
What speed should I use to engrave Paper on the xTool S1?
The top-rated community setting uses 6000 mm/min at 10% power. Engrave/score paper. Very low power to avoid burning through.
How many passes does the xTool S1 need to cut Paper?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Paper on the xTool S1?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What software do I use with the xTool S1 for Paper?
The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Paper
Templates ready to cut on your xTool S1 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris