ACMER P2 33W — Kraft Paper
2 community-tested settings for engrave, cut Kraft Paper on the ACMER P2 33W. Always run a test on scrap material first.
These 2 settings cover engrave and cut Kraft Paper on the ACMER P2 33W (33W diode laser). Keep speeds high and power low to avoid burning through; masking tape on the surface reduces scorching around cut edges.
2 settings
Frequently asked questions
What speed should I use to engrave Kraft Paper on the ACMER P2 33W?
The top-rated community setting uses 7000 mm/min at 18% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the ACMER P2 33W need to cut Kraft Paper?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Kraft Paper on the ACMER P2 33W?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Kraft Paper on the ACMER P2 33W?
Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
Now make something with Kraft Paper
Templates ready to cut on your ACMER P2 33W once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris