ComMarker B4 — Gold-Filled Jewellery

What speed should I use to mark Gold-Filled Jewellery on the ComMarker B4?

The top-rated community setting uses 1200 mm/s at 30% power. Very low power — gold layer is thin. Test on scrap first.

How many passes does the ComMarker B4 need to engrave Gold-Filled Jewellery?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Gold-Filled Jewellery on the ComMarker B4?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Gold-Filled Jewellery on the ComMarker B4?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the ComMarker B4 for Gold-Filled Jewellery?

The ComMarker B4 works with EzCad2 and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.