Creality Falcon — Genuine Leather

Creality 10W official parameter table (Scribd 651622034) lists 20% power at 3000 mm/min for 0.65mm brown leather engrave, 1 pass. 5W community on Creality forum scales power slightly higher (~25%) to achieve comparable mark depth. crealityfalcon.com blog 'How to Laser Engrave and Cut Leather' confirms general leather engrave speed range and advises against air assist to avoid excessive blow-off on thin leather.

Dark mark on vegetable-tanned leather at 45%. The Creality Falcon handles leather well — CO2 would give better results but the Falcon produces clean, saleable engraving at a fraction of the cost. Test on your specific leather as chrome-tanned gives lighter marks.

Engraves thin leather well. Darker mark at 55% power. Best on light-coloured veg-tan. Test on scrap first.