Creality Falcon: Polypropylene (Coroplast)
2 community-tested settings for cut, engrave Polypropylene (Coroplast) on the Creality Falcon. Always run a test on scrap material first.
Where to buy
Creality Falcon: check current price & availability
Affiliate link: we may earn a small commission at no extra cost to you.
These 2 settings cover cut and engrave Polypropylene (Coroplast) on the Creality Falcon (10W diode laser). Some settings use multiple passes for a cleaner cut: pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to cut Polypropylene (Coroplast) on the Creality Falcon?
The top-rated community setting uses 400 mm/min at 65% power, 7 passes. Air assist strongly recommended to clear melted plastic and keep the flutes from re-fusing. Typical corrugated board is ~4mm.
How many passes does the Creality Falcon need to cut Polypropylene (Coroplast)?
Settings here range from 1 to 7 passes. Multiple passes give a cleaner edge but increase the risk of material shift: always pin or tape your material flat before running.
Do I need air assist for Polypropylene (Coroplast) on the Creality Falcon?
Yes: 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
Now make something with Polypropylene (Coroplast)
Templates ready to cut on your Creality Falcon once you've dialed in the settings.
"Used it with a Glowforge: engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
: Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once: making that job so much easier."
: Camp
"Excellent quality and design. Cut clean and neat!"
: LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
: Bruce
"Excellent quality. Item as described. Expectations exceeded."
: Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
: chris