Glowforge Pro — Photopolymer Stamp Blank

What speed should I use to engrave Photopolymer Stamp Blank on the Glowforge Pro?

The top-rated community setting uses 120 mm/s at 45% power. 500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

Can the Glowforge Pro cut Photopolymer Stamp Blank?

Cutting Photopolymer Stamp Blank on the Glowforge Pro may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Glowforge Pro need to engrave Photopolymer Stamp Blank?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Photopolymer Stamp Blank on the Glowforge Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Photopolymer Stamp Blank on the Glowforge Pro?

Settings here use 450 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Glowforge Pro for Photopolymer Stamp Blank?

The Glowforge Pro works with Glowforge App. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.