Photopolymer Stamp Blank

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

Good relief depth on photopolymer at 60W. Start conservative — photopolymer can melt rather than ablate at too-high power. Test on off-cuts first. Invert design.

UV photopolymer blanks can be laser engraved with CO2. Use high DPI for fine text. Transparent blanks benefit from a white paper underlay to help absorb the beam. Less deep than rubber at same power.

What are the best laser settings for Photopolymer Stamp Blank?

A top-rated community setting for Photopolymer Stamp Blank on the Sculpfun S30 Pro is speed 2500 mm/min, power 60%. There are 9 community-tested settings for Photopolymer Stamp Blank across 9 machines on this page.

Can a diode laser engrave or cut Photopolymer Stamp Blank?

Yes - there are 3 community settings for Photopolymer Stamp Blank on diode lasers and 6 on CO₂ lasers. CO₂ lasers generally cut faster and cleaner, but modern high-wattage diode lasers handle most other work well.