K40 CO2 — Rubber Stamp Material
2 community-tested settings for cut, engrave Rubber Stamp Material on the K40 CO2. Always run a test on scrap material first.
Where to buy
Buy the K40 CO2 — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover cut and engrave Rubber Stamp Material on the K40 CO2 (35W CO₂ laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition.
2 settings
Frequently asked questions
What speed should I use to cut Rubber Stamp Material on the K40 CO2?
The top-rated community setting uses 7 mm/s at 85% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the K40 CO2 need to cut Rubber Stamp Material?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Rubber Stamp Material on the K40 CO2?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What DPI should I use to engrave Rubber Stamp Material on the K40 CO2?
Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.
Now make something with Rubber Stamp Material
Templates ready to cut on your K40 CO2 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris