LaserPecker 4 — Carbon Steel

What speed should I use to mark Carbon Steel on the LaserPecker 4?

The top-rated community setting uses 1500 mm/min at 85% power. Dark oxide mark on carbon steel — great for tool marking, knife blades, and industrial parts. The LP4 is popular with tradespeople who need to mark their tools with names or ID numbers on-site. Permanent marks that survive harsh use.

How many passes does the LaserPecker 4 need to engrave Carbon Steel?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Carbon Steel on the LaserPecker 4?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Carbon Steel on the LaserPecker 4?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the LaserPecker 4 for Carbon Steel?

The LaserPecker 4 works with LaserPecker. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.